A detailed How-To for locally installing modules

Corion has asked for the wisdom of the Perl Monks concerning the following question:

As a lowly user without root access (on some machines), I sometimes have to install Perl modules to run other software. I know that it is, in general, possible to create a "local" installation, where all modules reside in their respective subdirectories to the program directory and/or the current directory.

But as I found, it is not as easy to give the "right" options to both, ppd and Makefile.pl, as I think it should be. If some kind soul could either point me to a page with detailed instructions on how to make both methods of installation (CPAN/ppd and manual installation) work with non-root, I'd be very grateful.

PS: By detailed, I mean a bit more than just "perl -w Makefile.pl --help" or "just add the right prefix" - something more user friendly.

Comment on A detailed How-To for locally installing modules

Replies are listed 'Best First'.
Re: A detailed How-To for locally installing modules by httptech (Chaplain) on May 18, 2000 at 15:04 UTC
It's really not that difficult, so a "detailed how-to" isn't much longer than a few paragraphs. Look near the bottom of this page, under How do I install the module? Locally installing a binary module for Win32 is even easier, just unzip the package, go to the "x86" directory and unzip the .tar.gz file, then `use lib './x86/blib/lib';`	[reply] [d/l]
RE: Re: A detailed How-To for locally installing modules by misty (Hermit) on May 18, 2000 at 18:44 UTC
Or.. using CPAN under *nix: `cpan> o conf makepl_arg PREFIX="/path/to/module"` [download] Under Win32 using PPM: `PPM> set root c:\yourpath PPM> set build c:\yourpath` [download]	[reply] [d/l] [select]
RE: RE: Re: A detailed How-To for locally installing modules by httptech (Chaplain) on May 18, 2000 at 20:05 UTC
If you want to use CPAN as a non-privleged user, you'll also have to create a local copy of CPAN/Config.pm in $HOME/.cpan/CPAN/MyConfig.pm and use it to override the default paths for the CPAN installation, otherwise you won't even be able to start the CPAN interface.	[reply]
Re: RE: Re: A detailed How-To for locally installing modules by hanenkamp (Pilgrim) on Aug 27, 2003 at 19:02 UTC
I ran into an additional problem: a tool tries to mess around with the site directory. You also need to modify the CPAN configuration SITEPREFIX to your local perl directory in some cases.	[reply]


good chemistry is complicated, and a little bit messy -LW
	PerlMonks