Have you done anything like this before?
It's a couple of decades since I last had anything to do with electronics and the world has moved on a bit since then!
Ensuring you know what you're buying, before you buy it is the only sensible way to approach this sort of thing
Yes - I can see this being problematic...
I have found a review on Amazon that says it is Plug-and-Play and implies that it 'just works'. Although I have it plugged into a Windows 10 laptop which recognises it correctly but doesn't give me any clues other than it is successfully configured using a generic driver utilising input.inf which is a start but not very helpful.
I'm beginning to think that the GPIO route is going to be simpler than USB. At least with GPIO, there is a helpful Amazon review that very clearly shows the set up with a picture.
Are you posting in the right place? Check out Where do I post X? to know for sure.
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
Want more info? How to link or
or How to display code and escape characters
are good places to start.