comment on

correct
BTW I experienced some another problem on Windows 7 with 32bit ActiveTcl, so it took me some effort but then I switched to http://www.bawt.tcl3d.org/download.html#tclbi which then solved all my problems, there are 32 and 64 bit versions, with lots of modules included

I found this binary while searching in Tclers wiki at http://wiki.tcl-lang.org/page/BAWT, which is also recommended resource for seekers of perl/Tk wisdom :)

Going to write about this to Jeff Hobbs, who should be aware of such problems in ActiveTCL

regards, Vadim

In reply to Re^3: Tkx not installing properly by vkon
in thread Tkx not installing properly by freedee15

Are you posting in the right place? Check out Where do I post X? to know for sure.
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big> <blockquote> <br /> <dd> <dl> <dt> <em> <font> <h1> <h2> <h3> <h4> <h5> <h6> <hr /> <i> <li> <nbsp> <ol> <p> <small> <strike> <strong> <sub> <sup> <table> <td> <th> <tr> <tt> <u> <ul>
Snippets of code should be wrapped in <code> tags not <pre> tags. In fact, <pre> tags should generally be avoided. If they must be used, extreme care should be taken to ensure that their contents do not have long lines (<70 chars), in order to prevent horizontal scrolling (and possible janitor intervention).
Want more info? How to link or How to display code and escape characters are good places to start.


The stupid question is the question not asked
	PerlMonks