The server that cbhistory runs on went down this afternoon due to a power failure. It had been up for over 205 days.
Power was restored within a minute and the machine rebooted without incident - except that it's NTP server was down due to the massive power failure now affecting NYC and much of the northeast US. I guess the hardware clock drifted quite a bit over the past 7 months. With no NTP server to reset the system time, it came up with the time set about 15 hours off. As a result, as soon as cbhistory would write new records to the database, it purged them back out again thinking they were over an hour old.
I just pointed xntpd at a server in Pennsylvania and the time is now correctly set. Cbhistory should be running properly again. ++bart for pointing out that it was down.
|90% of every Perl application is already written. ⇒|
Are you posting in the right place? Check out Where do I post X? to know for sure.
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
Want more info? How to link or
or How to display code and escape characters
are good places to start.