That's not really a wait issue. When closing a piped open filehandle, if the opened command exits with a non-zero and that's the only issue with the command, then $! is set to 0. So the code above is using the tertiary operater to check that condition. I thought that might be the issue too but the OP said it worked fine from the command line so more than likely there's either a path or permisssion issue.
Are you posting in the right place? Check out Where do I post X? to know for sure.
Posts may use any of the Perl Monks Approved HTML tags. Currently these include the following:
<code> <a> <b> <big>
<blockquote> <br /> <dd>
<dl> <dt> <em> <font>
<h1> <h2> <h3> <h4>
<h5> <h6> <hr /> <i>
<li> <nbsp> <ol> <p>
<small> <strike> <strong>
<sub> <sup> <table>
<td> <th> <tr> <tt>
Snippets of code should be wrapped in
<code> tags not
<pre> tags. In fact, <pre>
tags should generally be avoided. If they must
be used, extreme care should be
taken to ensure that their contents do not
have long lines (<70 chars), in order to prevent
horizontal scrolling (and possible janitor
Want more info? How to link or
or How to display code and escape characters
are good places to start.