in reply to Re^4: Can't load LibXML.so for module XML::LibXML: libz.so.1: cannot open shared object file (64 32 bit dont mix)
in thread Can't load LibXML.so for module XML::LibXML: libz.so.1: cannot open shared object file

even if libperl.so is available.

Maybe some other dll isn't, run ldd -v ...so / ldd -v ..so like this and try to figure out which, then try one of the solutions (adjust paths ... )

Or maybe you just need to run citrusvars.sh

  • Comment on Re^5: Can't load LibXML.so for module XML::LibXML: libz.so.1: cannot open shared object file (64 32 bit dont mix)

Replies are listed 'Best First'.
Re^6: Can't load LibXML.so for module XML::LibXML: libz.so.1: cannot open shared object file (64 32 bit dont mix)
by jes (Novice) on Jul 23, 2013 at 08:50 UTC

    Thank you so much for the reply. I had skipped relocate perl.When i did ../perl/bin/relocateperl the error was cleared.

[reply]

      I wanted to install few modules so i used CPAN to install them. Most of the modules were successfully installd. Did /opt/citrusperl/perl/bin/cpan install XML::LibXSLT to install the module XML::LibXSLT.

      But this module is not installed successfully.

      ERROR:

      .........
/usr/bin/ld: cannot find -lgdbm
collect2: ld returned 1 exit status
make: *** [blib/arch/auto/XML/LibXSLT/LibXSLT.so] Error 1
  SHLOMIF/XML-LibXSLT-1.81.tar.gz
  make -- NOT OK
Running make test
  Can't test without successful make
Running make install
  Make had returned bad status, install seems impossible

      [download]
      Did i miss something to install? Looking forward for your reply
[reply]
[d/l]
[reply]

In Section Seekers of Perl Wisdom