Re^2: CPAN Module help

OK, do you mind being very specific. I ran perl -MCPAN -e shell.

o conf shows me that mbuildpl_arg and makepl_arg are not set.
They are set to [].

The build dir is set to /root/.cpan/build.

So can you give me an example of how I would set the correct config options so that CPAN will install the modules into the /usr/lib64/perl5/vendor_perl directory? Would I need to set more than the mbuild_install_arg?

Comment on Re^2: CPAN Module help

Replies are listed 'Best First'.
Re^3: CPAN Module help by tman77 (Initiate) on Jan 08, 2015 at 17:01 UTC
As a follow up, I tried setting the following via o conf and made sure I committed it `makepl_arg [INSTALL_BASE=/usr/lib64/perl5/vendor_perl] mbuildpl_arg [--install_base=/usr/lib64/perl5/vendor_perl]` [download] And I then tried to install a module, and it still installed to /root/perl5/lib/perl5/x86_64-linux-thread-multi	[reply] [d/l]
Re^4: CPAN Module help by Anonymous Monk on Jan 08, 2015 at 22:19 UTC
Which cpan did you use? Which perl does it uses? How many perls do you have installed?	[reply]
Re^3: CPAN Module help by choroba (Cardinal) on Jan 08, 2015 at 16:59 UTC
Do you have the mentioned variables set? لսႽ† ᥲᥒ⚪⟊Ⴙᘓᖇ Ꮅᘓᖇ⎱ Ⴙᥲ𝇋ƙᘓᖇ	[reply]