in reply to Re: Reading a password from the user
in thread Reading a password from the user

Though, I've tried this before, I downloaded both the modules (Term::ReadKey, Term::ReadPassword) from CPAN...
They dont seem to work when i run them. I'm able to 'use' it but the modules don work. I have active perl 5.8 for windows.
... but it seems that once you have it properly installed, its easy after that...
Any Alternatives?...thanks!
  • Comment on Re: Re: Reading a password from the user

Replies are listed 'Best First'.
Re: Re: Re: Reading a password from the user
by helgi (Hermit) on Apr 04, 2003 at 13:57 UTC
    Downloading them is not. You have to install them.

    How do you do that?

    Well, if you prefer to do it by hand as you evidently do, you should read the README file that is part of the tarball (.tar.gz file) you downloaded from CPAN.

    First you unpack it with gunzip and tar, then:

     perl Makefile.PL
 make
 make test
 make install

    [download]

    For the final, make install step, you need to be root.

    --
    Regards,
    Helgi Briem
    helgi AT decode DOT is

[reply]
[d/l]
      You can also do perl -MCPAN -e "install Term::ReadPassword" and follow instructions.

      OR, on windows use PPM for installing compiled modules for ActivePerl. It should be in your ActivePerl installation. 

      -- 
Joost       downtime n. The period during which a system
            is error-free and immune from user input.

      [download]
[reply]
[d/l]
[select]
Re: Re: Re: Reading a password from the user
by dga (Hermit) on Apr 04, 2003 at 16:53 UTC

    For Active State's perl on Windows, there is a bundled module installer. I would recommend trying to use that to get the modules properly set up to use in AS perl.

[reply]

In Section Seekers of Perl Wisdom