Re: Re^2: Trouble Compiling Term::ReadKey (Configure)

Hmm, I'm no expert in building perl, so I didn't know about that, but it sounds reasonable.
(looking into my configuration with "perl -V")
Yes, the C-compiler is set there, and the flags etc. as well. So, OP, which compiler was used in building perl?

daniel.

Comment on Re: Re^2: Trouble Compiling Term::ReadKey (Configure)

Replies are listed 'Best First'.
Re: Re: Re^2: Trouble Compiling Term::ReadKey (Configure) by Mark2117 (Initiate) on Sep 02, 2003 at 20:16 UTC
I am unsure what perl was built with. The only compiler I have available is CC and in the makefile stated cc=gcc. Any suggestions? Would installing GCC fix it?? --Mark	[reply]
Re^5: Trouble Compiling Term::ReadKey (Configure) by tye (Sage) on Sep 02, 2003 at 21:04 UTC
Sounds like your copy of Perl was built with gcc (because Config.pm says to use gcc) so, yes, I'd install gcc and try again. - tye	[reply]
Re^4: Trouble Compiling Term::ReadKey (Configure) by macakd (Initiate) on Aug 26, 2004 at 02:18 UTC
I have problem compiling Term::ReadKey module using CPAN. The error message is: make: *** No rule to make target `/usr/lib/perl5/5.8.3/i386-linux-thread-multi/CORE/config.h config.h doesn't exist at all. I'm using Mandrake 10. What's the problem??? Thanks	[reply]