Ok this worked! However, I need it to work programatically. So i attempted to integrate the tunnel into the program.

It opens fine, I can be on the sshHost machine and see the tunnel up and running. However the program itself locks at that point. Sadness, right?

I can not figure out why it is locking. I have a sub that opens the tunnel, and then after that it should run the telnet sub (which works if I open the tunnel manually). At that point it just hangs. Any more suggestions?

It is hanging at the following

channel 1: open confirm rwindow 0 rmax 32768

This only happens when I open the tunnel. If I send other commands like "who", etc.. it does not hang at all.

In reply to Re^2: Passing telnet commands through SSH by SiliconeClone
in thread Passing telnet commands through SSH by SiliconeClone

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.