G'day cavac,

"Your solution is probably a lot faster, ..."

I've always found for to be faster than map so I benchmarked. I ran the following with: 0 .. 5 (from the two nodes on which you commented); 0 .. 40 (the OP's original range); and, 0 .. 5000 (just to see if a large range made any significant different). 

#!/usr/bin/env perl

use strict;
use warnings;

use Benchmark 'cmpthese';

cmpthese 0 => {
    with_for => \&with_for,
    with_map => \&with_map,
};

sub with_for {
    my @f;
    push @f, [$_+2, $_+1] for 0 .. 5;
}

sub with_map {
    my @f = map [$_+2, $_+1], 0 .. 5;
}

[download]

I ran each three times; there was little difference in the results; I've just posted the middle results below. 

# 0 .. 5
             Rate with_map with_for
with_map 602818/s       --     -23%
with_for 780657/s      30%       --

# 0 .. 40
             Rate with_map with_for
with_map  92655/s       --     -23%
with_for 120756/s      30%       --

# 0 .. 5000
          Rate with_map with_for
with_map 745/s       --     -23%
with_for 968/s      30%       --

[download]

The smallest difference was -21% vs. 27%; the largest was -25% vs. 33%. As the range was increased, all values tended towards -23% vs. 30% (the middle values for all runs).

In this instance, for is faster than map (i.e. what I've always found in the past).

— Ken

In reply to Re^5: How Perl can push array into array and then how retrieve [Benchmark] by kcott
in thread How Perl can push array into array and then how retrieve by Anonymous Monk

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.