I bet that the biggest contributor to this is that you are "suffering from buffering". When the output from dispatcher is going to a terminal, then that output is "line buffered" which means each line of output appears immediately. When that output is going through a pipe, then it is "fully buffered" which means no output will flow into the pipe until the internal I/O buffer fills up (for example, no output until at least 4KB of output is produced and then the first 4KB of output goes into the pipe at once).

The easiest improvement is to just add $| = 1; to your dispatcher script.

- tye        

In reply to Re: pipe issue (linux) (buffering) by tye
in thread pipe issue (linux) by leostereo

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.