About the SOPW problem: I was on at the time, and as far as I could see, it wasn't the post. I didn't announce anything at the time because the conversation in chatterbox had already shifted to the view that it wasn't the node.

I'm a bit suprised there's such a slow response time for European times like you report. My usual morning routine is to take care of outstanding nodes (except tutorials) and then check every couple of hours from that point on.

I will be gone next month, however, so there will be a lot less editing from me until August.

In reply to (kudra) Re2: More Non-US Editors Needed? by kudra
in thread More Non-US Editors Needed? by footpad

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.