Hello,

I ran into similar problem a while ago, and found the explanation
in the Practical mod_perl book very helpful.
Almost the same explanation plus the solutions to the problem are
available on-line: Name collisions with Modules and libs.
There are also pluses and minuses of the solutions described there.
I am not going to rewrite this document here, as it is well informative
and I am strongly against retyping any source information.

For my particular problem I used the "quick but ineffective hackish solution",
with deleting $INC{"mymodule.pm"} and unshifting @INC within the BEGIN block,
when it was necessary, and then normally with "use mymodule;".

Regards,

-sheep

In reply to Re: Name-Space problems migrating to Apache::Registry by sheep
in thread Name-Space problems migrating to Apache::Registry by edan

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.