You've had some good advice, particularly doing the join on the database rather than in Perl. I'd like to comment on the following observation:

it seems to crunch about 5000 rows at once then rests for 5 minutes. I'm not sure what it's doing.

This is probably due to buffering; output is accumulating in a buffer at a relatively steady rate until the buffer fills, then you get a whole lot of results as the buffer is flushed. As you're doing the join manually in Perl, this is most likely to be buffering of Perl's output, so I'm guessing you must be writing to a file (Perl 'typically' has line buffering when writing to a terminal and block buffering otherwise).

HTH

Roger

In reply to Re: Speed up DBD::MySQL Queries by Roger_B
in thread Speed up DBD::MySQL Queries by awohld

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.