I would likely open the file for *reading* and search, using a while loop and the match operator, for the 'email' record. If that exists then exit. Otherwise, seek to the beginning of the file, open a new file and write the contents of the existing file to the new file, adding the desired record at some point. How this is done would depend on the format of your file. (If it consists of lots of lines of text, then you can use the match operator to decide when to insert the desired record.) Finally, I'd rename the old file (with a .bak suffix perhaps) and the newly written file to "people.dat" or whatever.
(Opening the file in append mode will only allow you to add the new record at the end, but if that's what you want then you might do that. You won't be able to add a line in the middle of the file, though.)
(Update: Of course, do some torture tests with your code to make sure it works as desired before putting it into production.)

In reply to Re: Check For Dupes In FLat DB Before Adding by chas
in thread Check For Dupes In FLat DB Before Adding by lisaw

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.