That makes a certain amount of sense. Traditionally software handshaking was only used for keyboard/terminal devices where on 'printable' character code were data and the control characters are reserved for control purposes. xon/xoff being done with ^Q/^S and the other control characters had defined meanings: 

SOH (Start of Heading)
STX (Start of Text)
ETX (End of Text)
EOT (End of Transmission
ENQ (Enquire)
ACK (Acknowledge)
BEL (Bell)
BS  (Backspace)
HT  (Horizontal Tab)
VT  (Vertical Tab)
FF  (Form Feed)
SO  (Shift Out)
SI  (Shift In)
DLE (Data Link Escape)
DC1 (Device Control 1/X-On)
DC2 (Device Control 2)
DC3 (Device Control 3/X-off)
DC4 (Device Control 4)
NAK (Negative Acknowledgement)
SYN (Synchronous Idle)
ETB (End of Transmission Block)
CAN (Cancel)
EM  (End of Medium)
SUB (Substitute)
ESC (Escape)
FS  (File Separator)
GS  (Group Separator)
RS  (Record Separator)
US  (Unit Separator)

[download]
It's quite possible that the serial device driver retains special handling for some of those characters when xon is enabled.

With modern UARTs and FIFO buffering, handshaking is often unnecessary, at least at resonably low speeds, but if your device supports one of the flavours of hardware handshaking, it would be a good idea to enable that.

Examine what is said, not who speaks -- Silence betokens consent -- Love the truth but pardon error.
"Science is about questioning the status quo. Questioning authority".
In the absence of evidence, opinion is indistinguishable from prejudice.
"Too many [] have been sedated by an oppressive environment of political correctness and risk aversion."

In reply to Re^5: Win32:SerialPort not reading all characters by BrowserUk
in thread Win32:SerialPort not reading all characters by sxmwb

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.