'dmake' and 'mingw32-make' have slightly different syntax rules. With Strawberry Perl, when you run 'perl Makefile.PL', the makefile that gets produced is written according to dmake's rules - it doesn't work with 'mingw32-make'. To get that makefile to work with mingw32-make, you would either have to make amendments to it, or change $Config{make} to mingw32-make (and also patch ExtUtils::MakeMaker so that it is capable of writing a makefile that's compatible with mingw32-make). This could possibly be done, but no-one has yet bothered, afaik.

To find out the flavour of make that 'perl Makefile.PL' honours, you run perl -V:make (which is what Anonymous Monk was getting at).

Cheers,
Rob

In reply to Re: what is difference between dmake and mingw32-make?[OT] by syphilis
in thread what is difference between dmake and mingw32-make?[OT] by xiaoyafeng

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.