There is certainly always the potential for trouble when upgrading. As you point out lots of modules will typically be upgraded in the process too.

The last time I made a major change, I went from Perl 5.6 to Perl 5.10 (I skipped 5.8). And yes some stuff "broke". As I remember, some of this had to do with deprecated syntax of some code. It would work, but there would be warnings. So I had to make modifications to get things running "clean". In a few cases I had trouble installing a more up to date module and had to do some futzing around.

I'm an ActiveState user and I waited awhile after 5.10 became available so that I could get all the modules that I needed. If you are on Unix, that may not be an issue for you. My next adventure will probably be to just 5.12 as Active State isn't fully on-board with 5.14 yet.

You didn't mention if you were also upgrading from 32 to 64 bit. I don't know the pitfalls in that. But if you are doing that, its probably worth a separate question.

Overall the impact of upgrading was well worth it. The performance of some things that I care greatly about, like sort is vastly better in Perl 5.10 vs 5.6. And I've found that backward compatibility is very good.

In reply to Re: Major differences in Perl 5 versions by Marshall
in thread Major differences in Perl 5 versions by Only1KW

Title:
Use:  <p> text here (a paragraph) </p>
and:  <code> code here </code>
to format your post, it's "PerlMonks-approved HTML":


  • Posts are HTML formatted. Put <p> </p> tags around your paragraphs. Put <code> </code> tags around your code and data!
  • Titles consisting of a single word are discouraged, and in most cases are disallowed outright.
  • Read Where should I post X? if you're not absolutely sure you're posting in the right place.
  • Please read these before you post! —
  • Posts may use any of the Perl Monks Approved HTML tags:
    a, abbr, b, big, blockquote, br, caption, center, col, colgroup, dd, del, details, div, dl, dt, em, font, h1, h2, h3, h4, h5, h6, hr, i, ins, li, ol, p, pre, readmore, small, span, spoiler, strike, strong, sub, summary, sup, table, tbody, td, tfoot, th, thead, tr, tt, u, ul, wbr
  • You may need to use entities for some characters, as follows. (Exception: Within code tags, you can put the characters literally.)
            For:     Use:
    & &amp;
    < &lt;
    > &gt;
    [ &#91;
    ] &#93;
  • Link using PerlMonks shortcuts! What shortcuts can I use for linking?
  • See Writeup Formatting Tips and other pages linked from there for more info.