How do we run perlscript thro' XEMACS

Anonymous Monk has asked for the wisdom of the Perl Monks concerning the following question:

Hai to everyone

How do we run perlscript in XEMACS? kindly reply the command key which is used to run the perlscript in XEMACS

Thanks in advance

Rudhra

Comment on How do we run perlscript thro' XEMACS

Replies are listed 'Best First'.
Re: How do we run perlscript thro' XEMACS by chanio (Priest) on May 15, 2004 at 05:37 UTC
I guess that you need to have that module loaded. But I always load the script in xemacs, edit it, and at the Perl menu (right side) I choose: Check Syntax or Run (at the lower section of the submenu), and it compiles! I have noticed that it requires the sheBang on top to know that it is Perl stuff. If it doesn't know that it is a perl script, it doesn't show the perl menu. There is also the perldoc that you may read by highlighting a word. I wouldn't be able to write anything without the help of Xemacs. It is addictive! {\('v')/} _`(___)' __________________________	[reply]

Replies are listed 'Best First'.

Re: How do we run perlscript thro' XEMACS
by chanio (Priest) on May 15, 2004 at 05:37 UTC

Check Syntax or Run

I have noticed that it requires the sheBang on top to know that it is Perl stuff. If it doesn't know that it is a perl script, it doesn't show the perl menu.

There is also the perldoc that you may read by highlighting a word.

I wouldn't be able to write anything without the help of Xemacs. It is addictive!

{\('v')/} _`(___)' __________________________

[reply]