Debugging core files created by a perl script

cvg2mco has asked for the wisdom of the Perl Monks concerning the following question:

Replies are listed 'Best First'.
Re: Debugging core files created by a perl script by Tanktalus (Canon) on Nov 06, 2006 at 16:57 UTC
This looks vaguely familiar ... Ah yes, here it is... Debugging tips for segmentation faults?. I asked a similar question a while back - perhaps those responses will help you here? I can't recall which one in particular helped me past my problem at the time, but there are a lot of good suggestions there. Good luck!	[reply]
Re: Debugging core files created by a perl script by derby (Abbot) on Nov 06, 2006 at 16:21 UTC
What platform? (Linux, Sun, Win32?). At a minimum, you're going to have to have a perl that was built with debugging enabled (most are not by default). -derby	[reply]
Re^2: Debugging core files created by a perl script by cvg2mco (Novice) on Nov 06, 2006 at 16:33 UTC
Platform - SunOs - 5.8 Generic_117350-39 sun4u sparc SUNW,Sun-Fire-880 The same script is run on linux too - but it did not core. Was curious if there were any tools that i could use to step through the core file	[reply]
Re: Debugging core files created by a perl script by Steve_p (Priest) on Nov 07, 2006 at 02:49 UTC
Core dumps should never occur with Perl. If you are getting a coredump that is caused solely by Perl code, please use perlbug to file a bug report. Before sending, however, please try to isolate the problem to the simplest test case possible.	[reply]