Re^2: perl can't find my script on ubuntu

RedElk, thank you for your response. I've been trying to figure out how to change the directory from my home directory to the directory that I want to work off of such as the begperl directory in the Ubuntu terminal. You said you used to encounter this same problem before, but not any more because you changed the directory? How did you do so in the Ubuntu terminal?

Comment on Re^2: perl can't find my script on ubuntu

Replies are listed 'Best First'.
Re^3: perl can't find my script on ubuntu by RedElk (Hermit) on Dec 15, 2010 at 16:31 UTC
Roboticus touched on it in his post. The change directory command is `cd`. However, before I use `cd` I start with the list command `ls`. This allows me to see everything in my home directory. From there, I `cd` into the needed directory. I may alternate these commands two or three times depending upon what level I need to get to. Admittedly, I prefer visual queues. Your stylings may vary That being said, I'm always starting from my Ubuntu `home` directory. I would assume this is the case for you as well. But to check this, you can use the working directory command `pwd`. If you're not at your home directory use the `cd` command followed by nothing to navigate there.I've found this command line reference helpful. I still think that you need a '/' at the beginning of the line when you intend to navigate multiple directories on the command line such as when you try to run your `newline.pl` script. `perl /begperl/newline.pl ^` [download]	[reply] [d/l]

Replies are listed 'Best First'.

Re^3: perl can't find my script on ubuntu
by RedElk (Hermit) on Dec 15, 2010 at 16:31 UTC

Roboticus touched on it in his post. The change directory command is cd. However, before I use cd I start with the list command ls. This allows me to see everything in my home directory. From there, I cd into the needed directory. I may alternate these commands two or three times depending upon what level I need to get to. Admittedly, I prefer visual queues. Your stylings may vary

That being said, I'm always starting from my Ubuntu home directory. I would assume this is the case for you as well. But to check this, you can use the working directory command pwd. If you're not at your home directory use the cd command followed by nothing to navigate there.I've found this command line reference helpful.

I still think that you need a '/' at the beginning of the line when you intend to navigate multiple directories on the command line such as when you try to run your newline.pl script.

perl /begperl/newline.pl
     ^
[download]

[reply]
[d/l]