Re^3: decoding libpcap on windows

Definitely look at Net::Frame then. You can pull apart the packets by field so for instance, source and/or destination IP address and layer 4 port. You can also pull out the data - although you may have to unpack() or decode it as it will likely be in hex.

I found the documentation of Net::Frame and submodules very helpful on this front.

Comment on Re^3: decoding libpcap on windows

Replies are listed 'Best First'.
Re^4: decoding libpcap on windows by jwillis (Initiate) on Sep 27, 2012 at 10:39 UTC
did you use the net dump on windows? i am using activestate ppm and I did not see the net-frame available for windows. when i check the support table on the web site it says its only available on linux? Are there any tricks I can do to make it work on windows?	[reply]
Re^4: decoding libpcap on windows by jwillis (Initiate) on Sep 27, 2012 at 10:42 UTC
does the net-frame work on windows? the table for the PPM says its not available as a build for a windows. are you using the module on windows and if so what instructions did you use to do the build?	[reply]