in reply to Re^7: Using Data::Printer from the Perl debugger
in thread Using Data::Printer from the Perl debugger

Thanks! :)

I received a response from MARCEL:

Thank you for your mail. I am no longer maintaining any Perl modules. I've used PAUSE to give up primary maintainership of all DB::Pluggable modules, so they are now available for adoption using the ADOPTME mechanism (see https://pause.perl.org/pause/authenquery?ACTION=pause_operating_model#4_5_1_adoptme ). It's probably going to take a bit until the distribution shows up in the ADOPTME RT list.

Since you are using the module, maybe you would like to continue development of this distribution?

(As flattering as it is, I don't feel remotely qualified to take over maintainership. :)
  • Comment on Re^8: Using Data::Printer from the Perl debugger

Replies are listed 'Best First'.
Re^9: Using Data::Printer from the Perl debugger
by LanX (Saint) on Feb 26, 2023 at 22:18 UTC
    if

    > ADOPTME RT list.

    refers to the "Request Tracker" it won't show up, since RT was discontinued :(

    Cheers Rolf
    (addicted to the 𐍀𐌴𐍂𐌻 Programming Language :)
    Wikisyntax for the Monastery

[reply]
[reply]
        > Perhaps you had forgotten that the crisis had been averted?

        Silly me trusted the corrupt mass media

        https://en.wikipedia.org/wiki/Request_Tracker

        > RT was used by Perl's CPAN, but because of declining use, a sunset date of March 1, 2021 was announced at the Perl NOC on December 4, 2020. rt.cpan.org will sunset on March 1st, 2021.

        Cheers Rolf
        (addicted to the 𐍀𐌴𐍂𐌻 Programming Language :)
        Wikisyntax for the Monastery

[reply]

In Section Seekers of Perl Wisdom